39
EN-US
Commissioning
Safety
WARNING!
An electric shock can be fatal.
If the unit is connected to the grid during installation, there is a danger of serious injury and
damage to property.
► Only carry out work on the device if the power switch is in the - O - position.
► Only carry out work on the device when it has been disconnected from the grid.
WARNING!
Danger of electrical current due to electrically conductive dust in the device.
This can result in severe personal injury and damage to property.
► Only operate the device if an air filter is fitted. The air filter is a very important safety
device for achieving IP 23 protection.
General Commissioning of the power source is described in relation to a standard configuration for
the main usage scenario of TIG welding.
The standard configuration consists of the following system components:
- Power source
- TIG manual welding torch
- Gas pressure regulator
- Gas cylinder
Connecting the
Gas Cylinder
WARNING!
Danger of severe injury and damage to property if gas cylinders fall over.
► Securely set up the gas cylinders on a level and stable surface. Secure gas cylinders
to prevent them from falling over.
► Please observe the gas cylinder manufacturer's safety rules.
1 2
1
max. 5 bar
(72 psi)
To Next Page
Loading...
Need help?
General
