81
EN-US
Troubleshooting
General The power source is equipped with an intelligent safety system, which completely negates
the need for fuses. After correcting a possible error, the power source can be properly op-
erated again without having to change any fuses.
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
Serious personal injury and damage to property may result.
► All the work and functions described in this document must only be carried out by
trained and qualified personnel.
► Read and understand this document.
► Read and understand all the system component Operating Instructions, especially the
safety rules.
WARNING!
Danger from electrical current.
Serious injuries or death may result.
► Turn the mains switch of the power source to - O - and disconnect the power source
from the mains
► Secure all devices and components involved so they cannot be switched back on.
► After opening the device, use a suitable measuring instrument to check that electrically
charged components (such as capacitors) have been discharged.
WARNING!
Electrical current hazard caused by an inadequate ground conductor connection.
Serious personal injury and damage to property may result.
► Always use the original housing screws in the quantity initially supplied.
Displayed Faults
High temperature
"hot" is shown in the display
Cause: Operating temperature is too high
Remedy: Leave the device to cool (Do not switch off the device - the fan will cool the
device)
To Next Page
Loading...
Need help?
General
