82
dYn
dYn - arc force dynamic correction
Unit -
Setting range 0 - 100
Factory setting 20
0 soft, low-spatter arc
100 harder, more stable arc
To obtain optimum welding results, it will sometimes be necessary to adjust the arc-force
dynamic.
Functional principle:
at the instant of droplet transfer or when a short circuit occurs, there is a momentary rise
in amperage. In order to obtain a stable arc, the welding current is temporarily increased.
If the rod electrode threatens to sink into the weld pool, this measure prevents the weld
pool solidifying, as well as preventing more prolonged short circuiting of the arc. This
largely prevents the rod electrode from sticking.
FAC
Factory - Reset welding machine
- Press and hold the Store button for 2 s to reset the machine to the factory settings.
- When the digital display reads "PrG", the welding machine has been reset.
IMPORTANT! When the welding system is reset, all the personal settings in the set-up
menu are lost. Jobs are not deleted when the welding machine is reset - these are pre-
served. Parameter settings in set-up menu - level 2 are not deleted.
2nd
set-up menu - level 2: second level of the set-up menu
To Next Page
Loading...
Need help?
General
