Fuji Electric FVR-C11S-7EN Series - Trial Run

3 Operation 3-2
FVR-C11S-EN
3
Table 3-3-1 Runnin
g
command
3-3 Trial Run
The motor rotates when a frequenc
y
value and runnin
g
command are
input from the ke
y
pad panel or external si
g
nal terminal.
Refer to Table 3-3-1.
Use a low frequenc
y
(about 5Hz) for trial runs.
A frequenc
y
can be set usin
g
the built-in frequenc
y
settin
g
POT (VR) ,
and forward/stop can be performed usin
g
the ke
y
pad panel with the
functions set in the factor
y
.
Operation method Frequenc
y
settin
g
Runnin
g
command
Operation b
y
usin
g
ke
y
pad
panel
(When built-in POT (VR) is used)
The frequenc
y
increases when
the variable resistor is turned
clockwise and reduces when it is
turned counterclockwise.
The motor accelerates when the
variable resistor is turned clock-
wise durin
g
operation and decel-
erates when it is turned
counterclockwise.
(When the UP/DOWN ke
y
is
used)
Frequenc
y
increases when the
UP ke
y
is pressed.
It reduces when the DOWN ke
y
is pressed.
Operation starts when the RUN ke
y
is
pressed.
The motor decelerates and stops when
the STOP ke
y
is pressed.
Operation b
y
usin
g
external
si
g
nal terminal
z
When SW7 is set at CM
Connect external power suppl
y
and
turn FWD (REV) on to start. Turn it off
to brin
g
the inverter to deceleration
and stop.
z
When SW7 is set at P24
Turn FWD (REV) on to start. Turn it off
to brin
g
the inverter to deceleration
and stop.
Operation is not stopped althou
g
h the
STOP ke
y
is pressed.
Refer to section 2-3-3.