Error Code
277
Problem Solving
13
116-386 [Cause] The fax cable is not connected correctly.
[Remedy] Connect the cable securely, and then switch off the machine power,
make sure that the display is blank, and then switch on the machine
power. If the same message is displayed again, contact our
Customer Support Center.
Refer to "Replacing the Drum Cartridge" (P.230).
116-747 [Cause] Unable to complete scanning due to the scanning area being too
small.
[Remedy] Decrease the value of the Edge Erase or reduce the zoom ratio.
117-326
117-327
123-314
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the display is blank,
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
127-396 [Cause] Failed to create an e-mail data.
[Remedy] Press the control panel's <Stop> button, and try again.
133-226 [Cause] The specified country code is not supported by the machine or the
time is not set.
[Remedy] Set the country code or time again.
Refer to "Region" (P.194) and "Clock" (P.198).
134-210
134-211
[Cause] An error occurred during fax transmission.
[Remedy] Connect the cable securely, and then switch off the machine power,
make sure that the display is blank, and then switch on the machine
power. If the same message is displayed again, contact our
Customer Support Center.
Error Code Cause and Remedy
To Next Page
Loading...
Need help?
General
