Fax Procedure
181
Fax
4
2
Adjust the document guides to match the size
of the document loaded.
Note • When loading a large size document such as
A3, lift up the document feeder tray, and
open the document stopper rightward.
3
Load the document (the front side of 2-sided
document) face up in the center of the
document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly.
• The number of documents that can be
loaded in the document feeder is up to 250
sheets (P paper).
• When the document is loaded in the
document feeder, the document feeder tray
lifts up. You can set the timing of the lift. For
more information, refer to "5 Tools" > "Common Service Settings" > "Other Settings" > "Document
Feeder Tray Elevation" in the Administrator Guide.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with size
297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents.
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
1
Open the document cover.
Important • Ensure that the touch screen is active, and
then load a document. Otherwise, the
machine may not properly detect the
document size.
Do not apply excessive force to hold thick document on the document glass. It may break
the glass and cause injuries.
To Next Page
Loading...
Need help?
General
