154 Using the Operator Panel Menus
• Wireless LAN (DocuPrint CP215 w Only)
Purpose:
To enable the wireless connection.
Values:
NOTE:
• When you use the USB connection and do not use the wireless connection, you need to disable Wireless
LAN.
• Wireless Status (DocuPrint CP215 w Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wireless LAN is set to Enable.
• Wireless Setup (DocuPrint CP215 w Only)
Purpose:
To configure the wireless network interface.
Values:
Enable* Enables the wireless connection.
Disable Disables the wireless connection.
Good Indicates good signal strength.
Acceptable Indicates marginal signal strength.
Low Indicates insufficient signal strength.
No Reception Indicates that no signal is received.
Select
Access
Select the access point from the list. The access points are listed starting with the one in the
best communication condition.
WEP Key When you select an access point using WEP as the security method,
enter the WEP key. For 64bit keys, enter 10 hexadecimal characters.
For 128bit keys, enter 26 hexadecimal characters.
PassPhraseEntry When you select an access point using WPA, WPA2, or Mixed as the
encryption type, enter the passphrase of 8 to 63 alphanumeric
characters.
To Next Page
Loading...
Need help?
General
