156 Using the Operator Panel Menus
• WPS Setup (DocuPrint CP215 w Only)
Purpose:
To configure the wireless network using WPS.
Values:
NOTE:
• Instead of selecting Push Btn. Ctrl, you can also start WPS-PBC by pressing and holding the (Wi-Fi)
button.
• WPS 2.0 compliant. WPS 2.0 works on access points with the following encryption types: Mixed Mode PSK,
WPA-PSK-AES, WPA2-PSK-AES, WPA-PSK-TKIP, Open (No Security)
• This item is displayed when the Ethernet cable is disconnected and Wireless LAN is set to Enable.
• Init Wireless (DocuPrint CP215 w Only)
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all
wireless network settings are reset to their factory default values.
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wireless LAN is set to Enable.
•TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
NOTE:
• When you set an IP address in IPv6 mode, use the CentreWare Internet Services. For more information, refer
to the Help on the CentreWare Internet Services.
Push Btn.
Ctrl
Configures the wireless settings with the security method of WPS-PBC.
PIN Code Start
Config.
Configures the wireless settings using the PIN code assigned
automatically by the printer.
Print PIN
Code
Prints the PIN code. Confirm it when you enter the PIN code to your
computer.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
IPv4 Get IP
Address
DHCP/AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator
panel.
IP Address Manually sets the IP address allocated to the
printer.
Network Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
To Next Page
Loading...
Need help?
General
