Printer Connection and Software Installation 61
• Manual SSID Setup
1 Press the (Menu) button.
2 Select Admin Menu, and then press the button.
3 Select Network Setup, and then press the button.
4 Select Wireless Setup, and then press the button.
5 Select Manual Setup, and then press the button.
6 Enter the SSID, and then press the button.
7 Select the network mode from Infrastructure and Ad-hoc depending on your environment,
and then press the button.
If you select Infrastructure, proceed to step 8.
If you select Ad-hoc, proceed to step 9.
8 Select the encryption type from Mixed Mode PSK, WPA-PSK-TKIP, WPA2-PSK-AES, or WEP.
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
To use Mixed Mode PSK, WPA-PSK-TKIP, or WPA2-PSK-AES encryption:
a Select Mixed Mode PSK, WPA-PSK-TKIP, or WPA2-PSK-AES, and then press the
button.
b Enter the passphrase, and then press the button.
NOTE:
• A passphrase is an encryption key for WPA and WPA2 encryption which consists of 8 to 63 alphanumeric
characters. It may be described as a key on some access points or routers. For details, refer to the
manual supplied with the access point or router.
c
Proceed to step 10.
To use WEP encryption:
a Select WEP, and then press the button.
b Enter the WEP key, and then press the button.
c Select the desired transmit key from Auto or WEP Key 1 to WEP Key 4, and then press the
button.
d Proceed to step 10.
9 Select WEP for the encryption type.
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
a Select WEP, and then press the button.
b Enter the WEP key, and then press the button.
c Select the desired transmit key from WEP Key 1 to WEP Key 4, and then press the
button.
10 Confirm that Restart Printer to apply settings appears.
To Next Page
Loading...
