Printer Connection and Software Installation 73
Configuring USB Connection Settings
1 Confirm that the USB cable is connected to the computer and the printer, and the printer is
turned on.
NOTE:
• For Windows XP or Windows Vista, if Found New Hardware Wizard appears, click Cancel at this time.
2 Click the USB button on the Select a Connection Method screen.
The Plug and Play installation starts and the required driver and software are automatically
installed.
3 Click Finish to exit the wizard when the Ready to Print! screen appears. If necessary, click
Print Test Page to print a test page.
Configuring Ethernet Connection Settings
1 Click the Ethernet button on the Select a Connection Method screen.
2 Connect the Ethernet cable to the printer and turn on the printer, and then click Next.
3 Select a printer you want to install from the Printer list, and then click Next.
If the target printer is not displayed on the Printer list, click the Refresh button to refresh the list
or click Enter IP Address to add a printer manually.
In Enter IP Address, enter assigned IP address to the printer manually, and then click OK.
NOTE:
• If the target printer is not displayed on the list, ensure Ethernet cable is correctly inserted to the printer
and the router, and also confirm the printer IP address is properly appointed.
4 Confirm IP Mode and Type, and then click Next.
If you want to change the printer's IP address settings, click Advanced and configure the items
on the IP Address Settings screen. Especially if you want to set up printer with fixed IP, select
Static IP from Type.
5 Check and configure the printer information such as a printer name, default printer setting, printer
sharing setting, and then click Next.
6 Select the check box of the software and documentation you want to install, and then click
Install.
7 Click Finish to exit the wizard when the Ready to Print! screen appears. If necessary, click
Print Test Page to print a test page.
To Next Page
Loading...
Need help?
General
