118 Using the Operator Panel Menus
*1
IPsec feature is available only when IPsec is enabled on the CentreWare Internet Services.
•Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and then on again.
Values:
IPv4 Get IP Address DHCP / Autonet
*
Sets the IP address automatically. A random value in the range of
169.254.1.0 to 169.254.254.255 that is not currently in
use on the network is set as the IP address. The subnet mask is set
as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually on
the operator panel.
IP Address When an IP address is being set manually, the IP is allocated to
the printer using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
Subnet Mask When an IP address is being set manually, the subnet mask is
specified using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
255. 255.255.255.255 cannot be specified as the subnet
mask.
Gateway Address When an IP address is being set manually, the gateway address is
specified using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to
254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
IPsec
*1
Disable Disables IPsec.
LPD Disable Disables the Line Printer Daemon (LPD) port.
Enable
*
Enables the LPD port.
Port9100 Disable Disables the Port9100 port.
Enable
*
Enables the Port9100 port.
FTP Disable Disables the FTP port.
Enable
*
Enables the FTP port.
IPP Disable Disables IPP port.
Enable
*
Enables IPP port.
SMB (TCP/IP) Disable Disables SMB TCP/IP port.
Enable
*
Enables SMB TCP/IP port.
SMB (NetBEUI) Disable Disables SMB Net BEUI port.
Enable
*
Enables SMB Net BEUI port.
WSD Disable Disables WSD port.
Enable
*
Enables WSD port.
SNMP (UDP/IP) Disable Disables the Simple Network Management Protocol (SNMP) UDP port.
Enable
*
Enables the SNMP UDP port.
StatusMessenger Disable Disables the Status Messenger feature.
Enable
*
Enables the Status Messenger feature.
InternetServices Disable Disables an access to CentreWare Internet Services embedded in the
printer.
Enable
*
Enables an access to CentreWare Internet Services embedded in the
printer.
To Next Page
Loading...
Need help?
General
