Fuji Xerox DocuPrint P365 d User Manual

Using the Operator Panel Menus 119
*1
HTTP-SSL/TLS is available only when a certificate is created using CentreWare Internet Services. For details about creating a certificate, see
the Help on the CentreWare Internet Services.
•IP Filter
NOTE:
• IP Filter feature is available only when LPD or Port9100 under Protocol is set to Enable.
Purpose:
To block data received from certain IP addresses through the wired network. You can set up to five IP addresses. The change
becomes effective after the printer is turned off and then on again.
Values:
•IEEE 802.1x
NOTE:
• IEEE 802.1x feature is available only when the printer is connected using LAN cable and the IEEE 802.1x authentication is enabled
using CentreWare Internet Services. For details about setting IEEE 802.1x, see the Help on the CentreWare Internet Services.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on again.
Value:
•Initialize NVM
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting the
printer, all wired network settings are reset to their default values.
•Adobe Protocol
Purpose:
To spe c i fy PostSc ript
®
communication protocol for a parallel interface, you can configure the Adobe Protocol settings for
the wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Bonjour(mDNS) Disable Disables Bonjour® (mDNS).
Enable
*
Enables Bonjour (mDNS).
Telnet D isa ble
*
Disables Telnet.
Enable Enables Telnet.
HTTP-SSL/TLS
*1
Disable Disables HTTP-SSL/TLS.
Enable Enables HTTP-SSL/TLS.
No. n / Address (n is 1–5.) Sets the IP address for Filter n.
No. n / Mask (n is 1–5.) Sets the address mask for Filter n.
No. n / Mode (n is 1–5.) Off
*
Disables the IP Filter feature for Filter n.
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.
Disable Disables IEEE 802.1x.
Auto* Sets the PostScript
®
communications protocol automatically.
Standard Sets the PostScript
®
communications protocol to Standard.
BCP Sets the PostScript
®
communications protocol to BCP.
TBCP Sets the PostScript
®
communications protocol to TBCP.
Binary Sets the PostScript
®
communications protocol to Binary.

Fuji Xerox DocuPrint P365 d Specifications

General

Brand	Fuji Xerox
Model	DocuPrint P365 d
Category	Printer
Language	English