Operation
SystemLock permissions
You can initialise a SmartCard with one of the following permissions:
System The system starts following entry of the user PIN. You can change the user PIN.
Setup You can open and change the
BIOS Setup and change the user PIN.
System+Setup The system starts following entry of the user PIN. You can open and change the
BIOS Setup and change the user PIN.
Admin The system starts following entry of the user PIN. You can change the user PIN
an the administrator PIN, unlock locked SmartCards, open and change the
BIOS Setup and generate additional SmartCards for this system.
For instructions on how to install and operate
SystemLock, and how to initialise SmartCards, see the
"BIOS Setup" manual.
Operating the SmartCard reader
● Operating the internal SmartCard reader
Depending on the configuration level, the workstation can be switched on by inserting your
SmartCard. If the SmartCard reader has been released, the SmartCard reader indicator on the front
of the workstation flashes green.
● Operating the external SmartCard reader
After the workstation is switched on, you will be prompted to insert your SmartCard.
28 A26361-K665-Z126-1-19, edition 1
To Next Page
Loading...
Need help?
General
