Preparing for use
Initial switch-on: Software will be installed
If the workstation is integrated into a network, the user and server details as well as the network
protocol are required. Contact your network administrator if you have any questions about these
settings.
When you switch on your workstation for the first time the supplied software is installed and
configured. You should plan some time for this, as this process must not be interrupted.
!
Once the installation has been started the workstation must not be switched off!
During installation, the workstation may only be rebooted when you are requested to do so!
Otherwise the installation will not be performed correctly. If a fault occurs during the
installation, the contents of the hard disk must be completely restored.
You may require the Windows licence number during installation. This number is located on a sticker
on your workstation.
Switching on monitor and workstation
► Switch the monitor on (see the operating manual for the monitor).
► Switch on the workstation. To do this, follow the instructions below.
i
Depending on the version, your workstation is equipped with a main power switch on the
back of the casing in addition to the power button on the front. This differentiates between
the ways to switch on both workstation versions.
A26361-K665-Z126-1-19, edition 1 13
To Next Page
Loading...
Need help?
General
