Preparing for use
8 A26361-K675-Z120-1-7619, edition 3
Setting up the PC
!
When installing your PC, give consideration to the recommendations and safety notes in
the "Safety" manual.
Set up the PC only in its correct orientation. The points to observe are illustrated on the
following pages.
Do not expose the PC to extreme environmental conditions (see "Technical data"
chapter). Protect the PC from dust, humidity and heat.
When installing the PC, provide sufficient clearance around the PC, as indicated in the
"Technical data" chapter to ensure adequate ventilation. In order to avoid overheating, do
not cover the ventilation area of the monitor or the PC.
Do not place several PCs one above the other.
Depending on the location of your device, bothersome vibrations and noises may occur.
To prevent this, a distance of at least 3 mm should be maintained from other devices on
casing sides without ventilation surfaces. In addition, we recommend placing the device
on support feet, as these buffer vibrations.
The PC can be used either horizontally or vertically. We recommend that you place your equipment
on a surface with good anti-slip qualities. In view of the multitude of different finishes and varnishes
used on furniture, it is possible that the rubber / plastic feet of the devices will mark the surface they
stand on.
Vertical operating position
The vertical operating position is only permissible with base feet. The base feet secure the device
against tipping over. The base feet are not included in the delivery package and must be ordered
separately.
!
The set-up direction is specified. The ON/OFF switch must be at the top to ensure
sufficient ventilation.
To Next Page
Loading...
Need help?
General
