EasyManua.ls Logo

Fujitsu 5GRUDB3 - Page 72

Fujitsu 5GRUDB3
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 25 (Cont.)
Spurious Emissions
Frequency Range Maximum Level* Measurement Bandwidth
5091 MHz…5150 MHz < –30 dBm 1 MHz
5150 MHz…5350 MHz < –70 dBm 100 kHz
5350 MHz5470 MHz < –52 dBm 1 MHz
5470 MHz…5850 MHz < –70 dBm 100 kHz
5850 MHz5925 MHz < –52 dBm 1 MHz
5925 MHz…127500 MHz < –30 dBm 1 MHz
Transmier Intermodulation
e transmier intermodulation level does not exceed the unwanted emission limits in clauses ACLR, OBUE and
Spurious Emissions in the presence of an NR interfering signal according to the following criteria:
Wanted Signal type NR single carrier, or multi-carrier, or multiple intra-band contiguously or non-
contiguously aggregated carriers, with NB-IoT operation in NR in-band if
supported.
Interfering Signal type NR signal, the minimum base station channel bandwidth with 15 kHz SCS: 5 MHz
for n70, n66
Interfering Signal level Rated total output power (Prated, t, AC) in the operating band –30 dB
Interfering signal center frequency
oset from the lower/upper edge of
the wanted signal or edge of sub-
block inside a sub-block gap
for n=1, 2, and 3
Modulation Quality
Table 26
Error Vector Magnitude (EVM)
Modulation Scheme Required EVM Test Tolerance
QPSK ≤ 17.5% 1.0%
16QAM ≤ 12.5%
64QAM ≤ 8%
256QAM ≤ 3.5%
RU Hardware Feature
Performance Requirement
72
Release 1.0 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only