Fujitsu 5GRUDB3 - Page 73

Dynamic Range
Table 27
Total Power Dynamic Range (15 kHz SCS)
Base Station Channel Bandwidth (MHz) Total Power Dynamic Range Test Tolerance
5 ≥ 13.9 dB 0.4dB
10 ≥ 17.1 dB
15
1
≥ 18.9 dB
20 ≥ 20.2 dB
1
15 MHz is not currently supported.
Table 28
RE (Resource Element) Power Control Dynamic Range
Modulation Scheme Used On e RE
RE Power Control Dynamic Range
Down Up
QPSK Physical Downlink Control Channel
(PDCCH)
–6 dB +4 dB
QPSK (PDSCH) –6 dB +3 dB
16QAM PDSCH –3 dB +3 dB
64QAM PDSCH 0 dB 0 dB
256QAM PDSCH 0 dB 0 dB
Note: Total TX power is always less or equal to maximum base station output power.
FCC Out-of-Band Emission Specication
FCC rule
CFR 47 § 27.53, CFR 47 § 27.1134 for n70, n66
−19 dBm/RBW per port [= −13 dBm/single-transmit −6 dB (10 x log (4, No. of TX)].
Resolution Bandwidth for Frequency (RBW)
>1 MHz bands immediately outside and adjacent to the frequency block have the following specications:
n70 200 kHz (Max)
n66 200 kHz (Max)
Outside 1 MHz, the reference bandwidth (1 MHz) is applied.
RU Hardware Feature
Performance Requirement
73
Release 1.0 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only