111
5.6 [Authentication/Accounting]
[Invalid Login Settings] Sets this setting so that invalid operation is not performed through
impersonation. Sets the number of attempts until access is denied
for the [Maximum Failed Attempts], so that access is denied if there
are consecutive failures in authenticating the same user ID.
Note
When the machine is restarted, the number of failed attempts is reset.
When setting, set [Maximum Login Attempts - System Administrator]
or [Maximum Login Attempts - Local User] to [On].
Restart the machine to cancel the access denied state.
Maximum login attempts for local users can be set in the case of login
to local accounts.
[Password Policy]
[Password for Control
Panel Login]
Enables input of a password when a user uses the machine.
If set to [On], the [Password] for [Create/View User Accounts] is
enabled.
If set to [Off], password input is not required, even if a password is
specified with the above setting.
[Password for IC Card
Login]
Enables input of password when the administrator or user performs
IC Card login for log in to local accounts.
[Minimum Password
Length]
Specifies minimum password length.
[Maximum Password
Length]
Specifies maximum password length.
[Authentication from
External Services]
Set whether to accept authentication that does not involve login
operations such as print jobs when the set password no longer
satisfies the requirements as a result of changing the password
security strength.
[Charge/Private Print
Settings]
Sets for control of the Charge Print or Private Charge Print.
[Receive Control] Sets how to handle received print jobs.
[Control by Job
Login Results]
Sets handling of jobs for, respectively, [Job Login Success], [Job
Login Failure] and [Job Without User ID] when [Printer] of [App
Access] is set to [Locked] using the authentication/accounting
feature.
[Save as Private
Charge Print Job]
Saves all jobs with user ID attached as private charge prints,
regardless of whether the authentication feature is used or not. This
sets handling of jobs for, respectively, [Job Without User ID] and
[Non-PJL Command Jobs].
[Save as Charge
Print Job]
Saves all received jobs as charge prints, regardless of whether the
authentication feature is used or not.
Item Description
To Next Page
Loading...
Need help?
General
