62
5 Device
5.2 [System Settings]
[System Clock / Timers]
Item Description
[Date] Sets the date of the machine’s system clock.
[Time] Sets time of the machine’s system clock.
[NTP Time Synchronization] Retrieves time from server and adjusts the machine’s time to be the
same as time of the time server (NTP: Network Time Protocol).
[Time Synchronization
Interval]
Sets interval (in hours) for connecting to time server.
[Time Server Address] Sets server name or IP address of time server.
[Auto Clear] Sets whether auto clear is performed when a fixed time has passed
in a state with no operation. If [On] is selected, the time is set.
Even if this is set to [Off], if no operation is performed for 1 minute
while a job is suspended, auto clear may be performed and the job may
be resumed. Job operation after auto clear is set with “Paused Job
Handling”. For details of paused job handling, refer to "[Other
Settings]" (P.72).
[Auto Job Release] Sets the time for releasing the current job, until the next job can be
run, when an error (paper replenishing, paper jam, etc.) has
occurred.
[Specify Auto Print Time] Sets time until printing can be done after operating the touch panel
display (except [Start]).
[Time Zone] Sets within the range - 12 hours to + 12 hours relative to GMT.
[Daylight Savings] Sets daylight savings time. During the set period, time is determined
by adding 1 hour to the current time.
To Next Page
Loading...
Need help?
General
