Fujitsu DL3100 User Manual

FUJITSU DL3100
User’s Manual C-19
Function
Command
Counter specifies the number of times to repeat the next
byte of data
according to the formula below.
256 – (counter byte) + 1 = (number of times to repeat
next byte)
(counter byte) = 257 – (number of times to repeat next
byte)
(c = 0 ,1,v = 5,10, 20,h = 5,10, 20,m = 1, 8, 24)
(0 ≤ nL ≤ 255,0 ≤ nH ≤ 127,0 ≤ d ≤ 255)
The following vertical and horizontal printing resolution
combinations are available:
v h v(dpi) h(dpi) m
20
20
180
180
1,8 or 24
20
20
180
360
1,8 or 24
10
10
360
360
1,8 or 24
Stylus COLOR only
5 5 720 720 1(with special paper)
Notes
• Use only one image density and do not change this
setting once in raster graphics mode.
• When MicroWeave is selected, the image height m
must be set to 1.
• Special coated stock paper available from EPSON is
required when printing raster graphics at 720 dpi.
• This command can be used only during graphics
mode, entered by sending the ESC ( G command.
• The final print position is the dot after the far right dot
on the top row of the graphics printed with this
command.
• Print data that exceeds the right margin is ignored.
• Do not specify the vertical movement in increments
smaller than the current print density.

Fujitsu DL3100 Specifications

General

Brand	Fujitsu
Model	DL3100
Category	Printer
Language	English