Fujitsu DL3100 User Manual

FUJITSU DL3100
User’s Manual 5-5
Paper Setup
Valid Settings
Function
Fanfold Left
Mrg (1/90inch)
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
Define
Compensation value added to
Fanfold Left Mrg.
Fanfold Top
Mrg (1/180inch)
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
11, 12, 13, 14, 15, 16, 17, 18,
19, 20, 21, 22, 23, 24, 25, 26,
27, 28
Compensation value added to
Fanfold Top.
Fanfold Auto
Load
No, Yes
Yes: The printer loads paper to the
first printing position automatically
when using fanfold.
No: Press the [Load/Eject] key to
load paper when using fanfold.
Skip
No, Yes
Skips printing on perforation area.
Only valid to fanfold.
Yes: Blank lines between 2 pages.
No: No blank lines between 2 pages.
Tear
Auto, Manual,
View, Auto@FF
Auto: Form Feed command from the
host causes the printer to advance
the paper to the tear-off position.
Printing resumes on the TOF on next
page.
Manual: After the completion of a
print job, press a panel key to
advance the paper to the tear-off
position.
View: No incoming print data in 1~2
seconds after printing completed
causes the printer to advance the
paper by 2 lines. Printing resumes 2
lines below the torn edge.
Auto@FF: a formfeed command is
necessary to auto feed the form to
tear position.
Paper End
Detect
No, Yes
Yes: The printer stops printing if out
of paper.
No: The printer continues printing
even out of paper.

Fujitsu DL3100 Specifications

General

Brand	Fujitsu
Model	DL3100
Category	Printer
Language	English