FUJITSU DL3100
User’s Manual 5-39
7.When you respond with “OK” to set the vertical offset, the
printer prompts you to reload a black marked fanfold form:
Press any key to eject the paper, and load paper with black
mark in the Fanfold Path.
The top edge of the form will then align with the printer’s
tear-off blade. Press Next or Back to feed or reverse-feed the
paper till the desired first print line position is reached. (With
the above measured vertical position, the printer will convert
the next paper feeding to the TOF relative to the black mark.)
Press OK to confirm the vertical offset. Then the print
prompts the invitation for setting the tear-off position relative
to the black mark:
Successfully setup black mark parameters.
Distance Offset From Black Mark To Tear Position
8.When you respond with OK to set the tear-off position, the
printer prompts you to reload a black marked fanfold form:
Press any key to eject the paper, and load paper with black
mark in the Fanfold Path.
The printer reloads the form. By default the form stops 5.5
inches away from the printer’s tear-off blade. Press Next or
Back to feed or reverse-feed the paper till the desired tear-off
position is reached. (With the above measured vertical
position, the printer will convert the net paper feeding to the
tear-off position relative to the black mark.) Press OK to
confirm the tear-off offset relative to the black mark. Finally,
press Save and Restart to save new settings and terminate
the session.
To Next Page
Loading...
Need help?
General
