131
How to operate the Sound Adjustment Mode
IX
Press the [6] button to select the Q curve pattern.
Each time the button is pressed, the Q curve changes in the
following order.
Repeat the operations in steps to to
change the settings for each band.
Hold down a button, [1] to [5], for more than two
seconds to preset a value.
The preset value is overwritten by the value set using the
above steps.
The time alignment and crossover adjustments will also be
stored at this time.
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] button to exit sound adjustment
mode.
[
UND] button
[RTN] buttonButtons [1] to [6]
NORMAL SHARP SLOW
CD8455.book 131 ページ ２００４年１２月１１日 土曜日 午後７時２４分
To Next Page
Loading...
