4 Install the drive enclosure in the rack.
(1) Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front
and rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to
the rack before they can be completely tightened.
(Rear view of rack pillar)
(Front view of rack pillar)
Loosen the M4 screws to
adjust the length of the rack
rails to match the distance
between the front and
rear rack pillars.
Rack rail (left)
"L" indicated inside
Rack rail (right)
"R" indicated inside
[Left]
[Right]
(2) Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the rack
rails to the rear rack pillars.
Note
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any
space between them.
(Front view of rack pillar)
(Rear view of rack pillar)
Washer
M5 scr
ew
M5 screw
Washer
M5 screw
Plate
M5 screw
Plate
Rack rail (right)
Rac
k rail (left)
The M5 screw positions for the rack rails are determined by the drive enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the
2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
39 Operation Guide (Basic)
To Next Page
Loading...
