Front view of drive enclosure
Rear view of drive enclosure
2U
Rack rail
[Right][Left]
2U
Rack rail
[Right][
Left]
Sixth screw
(M5 screw)
First screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
Second screw
(M5 screw)
Sixth screw
(M5 screw)
Bottom position of
drive enclosure
Bottom position of
drive enclosure
(3) Tighten the M4 screws of the rack rails that were slightly unscrewed in Step (1).
(4) Install the drive enclosure in the rack.
• When installing or removing the drive enclosure to or from the rack,
make sure that the sides and the bottom of the drive enclosure are
held by two or more people. Failure to do so may cause injury.
(5) Fasten the drive enclosure in the rack.
Use four M5 screws to fasten it in the rack pillar.
4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
40 Operation Guide (Basic)
To Next Page
Loading...
