Fujitsu ETERNUS DX S5 Series - Page 209

Usage Protocol tcp / udp
Port
number
Direction
Master CM Slave CM
Remarks
MNT RMT MNT RMT
REMCS
(remote support)
smtp
(client)
tcp 25 (*2) to
¡ (*3) ¡ (*3)
´ ´
Used for
failure
notificatio
n, etc.
pop3
(client)
tcp 110 (*2) to
¡ (*3) ¡ (*3)
´ ´
Used for
SMTP
authentica
tion
http
(client)
tcp 80 or 8080
(*2)
to
¡ (*3) ¡ (*3)
´ ´
Used for
firmware
download,
etc.
AIS Connect (remote
support)
https
(client)
tcp 443 to
¡ (*3) ¡ (*3)
´ ´
—
Syslog
(event notification and
audit log sending)
Syslog udp 514 (*2) to
¡ (*3) ¡ (*3)
´ ´
—
RADIUS Radius udp 1812 (*2) to
¡ (*3) ¡ (*3)
´ ´
—
ping ICMP — — from
¡ (*3) ¡ (*3)
´ ´
—
KMIP (key
management)
SSL tcp 5696 (*2) to
¡ (*3) ¡ (*3)
´ ´
—
ECD (*4) Unique
protocol
udp 9686 from
¡
´ ´ ´
—
¡: Available / △: Available for some functions / ´: Not available
*1: Only the following functions are available:
• Checking the
ETERNUS DX status
• Switching the Master CM
*2: Can be changed.
*3: The MNT port or the RMT port will be used.
*4: Used with the Remote Installation function. ETERNUS Connection Detecting tool (ECD) is a Windows application for collecting the
network setting information of the
ETERNUS DX.
For details on the port numbers for the ETERNUS SF Software, refer to the manual of each Storage Foundation
Software ETERNUS SF.
5. Connection Configuration
LAN Connection
209 Design Guide