Fujitsu ETERNUS DX

To Next Page

To Previous Page

3 Set the topology to "p2p".

# bcu port --topology 1/0 p2p

Setting will be enforced after port --disable and --enable

4 Set the frame data size to "2048".

# bcu port --dfsize 1/0 2048

Setting will be enforced after port --disable and -enable

5 Execute the "port disable|enable" command to apply the port speed, topology, and frame data size set-

tings.

# bcu port --disable 1/0

port disabled

# bcu port --enable 1/0

port enabled

6 Check the port speed, topology, and frame data size that have been set.

• Port speed confirmation

# bcu port --speed 1/0

Current port speed is: 8G

Configured port speed is: 8G

• Topology confirmation

# bcu port --topology 1/0

Current topology is: P2P

Configured topology is: P2P

• Frame data size confirmation

# bcu port --dfsize 1/0

Port maximum receive data field size is 2048 -

To set multiple ports, repeat the above procedure for each port.

Chapter 4

Operations When Using Brocade Fibre Channel Cards

4.3 Setting Up the Server

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris

P3AM-6312-18ENZ0

Fujitsu ETERNUS DX - Page 79