Fujitsu Eternus DX600 S3 - Components (Front); Figure 5 Operation Panel (Controller Enclosure)

Components (Front)
This section describes the operation panel, PCIe Flash Module (PFM), and the batteries in the front of the con-
troller enclosure.
■
Operation Panel
An operation panel has LEDs, a Power switch, and setting change switches.
Figure 5 shows the operation panel. Table 1 shows the status and meanings of each LED.
Figure 5 Operation Panel (Controller Enclosure)
2
3
1
4
65
87
AB
9 11
10
A. With a flange cover
B. Without a flange cover and a front cover
1. Power switch
This switch is used to turn on or off the
ETERNUS DX.
2. POWER LED
3. IDENTIFY LED
4. FAULT LED
5. MAINTENANCE LED
6. CACHE LED
7. READY LED
8. REMOTE LED
9. MNT SW (maintenance switch)
This switch is used to switch the maintenance status on or off.
10. IP RST SW (IP reset switch)
This switch is used to initialize the LAN ports or to initialize the user information.
11. MST SW (CM Master Change switch)
This switch is used to change the Master CM.
1. Component Names and LED Names
Controller Enclosures
13
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0