Fujitsu Eternus DX600 S3 - Figure 15 Host Interface for LAN Cable Connections (2 Port); Table 5 Status and Meanings of each LED (Host Interface)

● Host Interface (for LAN Cable Connections) (2port)
The ports on the host interface are used for connecting a controller to a server with a LAN cable.
There is one type of 2port host interface for LAN cable connections: iSCSI 1Gbit/s.
Figure 15 Host Interface for LAN Cable Connections (2port)
4 5
12 3
1. CA FAULT LED
2. CA READY LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
The states of LEDs are listed below.
Table 5 Status and Meanings of Each LED (Host Interface)
LED name LED status Meanings
CA FAULT
(amber)
The host interface is in error status.
CA READY
(green)
The host interface is in normal status.
LINK/FAULT
(green)
The link between the host interface port and the destination port
has been established.
(amber)
The host interface port is in error status.
1. Component Names and LED Names
Controller Enclosures
21
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0