Fujitsu Eternus DX600 S3 - Figure 6 PFM; Table 1 Status and Meanings of each LED (Operation Panel (Controller Enclosure)); Table 2 Status and Meanings of each LED (PFM)

The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1 Status and Meanings of Each LED (Operation Panel (Controller Enclosure))
LED name LED status Meanings
POWER
(green)
Power is supplied to the controller enclosure.
IDENTIFY
(blinks blue)
The installation location of the controller enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI
or ETERNUS CLI.
FAULT
(amber) (*1)
The ETERNUS DX is in error status.
(blinks amber)
A part of the ETERNUS DX requires preventive maintenance.
MAINTENANCE
(green)
Maintenance for the ETERNUS DX is in progress.
(blinks green)
Maintenance (from ETERNUS Web GUI or ETERNUS CLI) for the
ETERNUS DX is in progress or a status check of the ETERNUS DX
is
necessary.
CACHE
(green)
There is data in the cache memory of the ETERNUS DX.
READY
(green) (*1)
The ETERNUS DX is available for use.
REMOTE
(green)
The ETERNUS DX is turned on and off with the server.
*1: When the READY LED and the FAULT LED are both on at the same time, an error has occurred while the
Unified configuration is starting up.
■
PCIe Flash Module (PFM)
A PFM is a module that is installed to operate the Extreme Cache function.
A PFM has LEDs.
Figure 6
shows the PFM. Table 2 shows the status and meanings of each LED.
Figure 6 PFM
1
2
1. READY LED
2. FAULT LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 2 Status and Meanings of Each LED (PFM)
LED name LED status Meaning
READY
(green)
The PFM is in normal status.
(blinks green)
The PFM is busy or temporarily unavailable.
1. Component Names and LED Names
Controller Enclosures
14
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0