Fujitsu Eternus DX600 S3 - Figure 20 Host Interface (4 Port); Figure 21 Host Interface (2 Port)

■
Host Interfaces
A host interface is a board that has interface ports to connect a controller to the server.
Figure 20
and Figure 21 show host interfaces. Table 8 shows the status and meanings of each LED.
● Host Interface (4port)
The ports on the host interface are used to connect host interface cables.
Two types are available for host interfaces (4port).
Figure 20 Host Interface (4port)
4 5 6 7
12
3 12 3
4 5 6 7
1. CA READY LED
2. CA FAULT LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
6. Host Interface Port #2
7. Host Interface Port #3
● Host Interface (2port)
The ports on the host interface are used to connect host interface cables.
The following figure shows an example of when the host interface is FC.
Figure 21
Host Interface (2port)
4 5
12 3
1. CA FAULT LED
2. CA READY LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
1. Component Names and LED Names
Controller Enclosures
26
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0