Fujitsu Eternus DX600 S3 - Figure 11 Host Interface for FC Cable Connections (4 Port); Figure 12 Host Interface for LAN Cable Connections (4 Port)

■
Host Interfaces
A host interface is a board that has interface ports to connect a controller to the server.
Figure 11
through Figure 15 show host interfaces. Table 5 shows the status and meanings of each LED.
● Host Interface (for FC Cable Connections) (4port)
The ports on the host interface are used for connecting a controller to a server with an FC cable.
There are two types of 4port host interfaces for FC cable connections: FC 16Gbit/s and FC 8Gbit/s.
Figure 11 Host Interface for FC Cable Connections (4port)
12 3
4 5 6 7
1. CA READY LED
2. CA FAULT LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
6. Host Interface Port #2
7. Host Interface Port #3
● Host Interface (for LAN Cable Connections) (4port)
The ports on the host interface are used for connecting a controller to a server with a LAN cable.
There is one type of 4port host interface for LAN cable connections: Ethernet 1Gbit/s.
Figure 12 Host Interface for LAN Cable Connections (4port)
12 3
4 5 6 7
1. CA READY LED
2. CA FAULT LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
6. Host Interface Port #2
1. Component Names and LED Names
Controller Enclosures
19
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0