● Controller (
ETERNUS DX600 S4)
Figure 9 shows the controller of the ETERNUS DX600 S4.
Figure 9 Controller (ETERNUS DX600 S4)
1. Host interface (CA#0)
Install host interfaces. For details, refer to "
■ Host Interfaces" (page 19).
2. Host interface (CA#1)
Install host interfaces. For details, refer to "
■ Host Interfaces" (page 19).
3. Host interface (CA#2)
Install host interfaces. For details, refer to "
■ Host Interfaces" (page 19).
4. Host interface (CA#3)
Install host interfaces. For details, refer to "
■ Host Interfaces" (page 19).
5. FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
6. RMT (LAN) port
This port is used for connecting a LAN cable and used for the remote support function. This port uses an RJ-45
connector.
7. MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45 con-
nector.
8. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between enclo-
sures.
9. PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
1. Component Names and LED Names
Controller Enclosures
17
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0
To Next Page
Loading...
