2 After approximately five to seven minutes (or approximately 10 to 12 minutes for a Unified configuration
and approximately 20 to 22 minutes for a VLAN/Bonding maximum configuration), check that the READY
LED of the controller enclosure is lit up.
Controller enclosure
Drive enclosure
Powering Off
This section explains how to turn off the ETERNUS DX.
To turn off the ETERNUS DX, perform one of the procedures below.
•
Via power switch
Press the Power switch to turn off the
ETERNUS DX.
•
Via ETERNUS Web GUI or ETERNUS CLI
Use ETERNUS Web GUI or ETERNUS CLI to turn off the ETERNUS DX.
The following methods can be used to turn off the power by linking with the server.
•
Via the power synchronized unit
Use the power synchronized unit to turn off the ETERNUS DX.
•
When turning off the ETERNUS DX, the power shuts off after the write data on the cache memory is written
back to the drives. As a result, it may take approximately five minutes (or approximately 10 minutes in a
Unified configuration and 20 minutes in a VLAN/Bonding maximum configuration) or a maximum of 10 mi-
nutes (or approximately 40 minutes in a Unified configuration and 50 minutes in a VLAN/Bonding maxi-
mum configuration) for the power supply to be completely turned off.
•
Do not turn off the power of the
ETERNUS DX and the network devices that connect the ETERNUS DX to a
server while the server is operating. This may result in the loss of data or prevent data from being saved in
the ETERNUS DX.
•
When using a power synchronized unit for power control, turn off the power of the ETERNUS DX via the pow-
er synchronized unit. When a power synchronized unit is connected, the power of the ETERNUS DX is auto-
matically turned on because the power synchronization function is activated.
•
If the REMOTE LED on the ETERNUS DX is green, turn off the ETERNUS DX by linking with the server. Pressing
the Power switch does not turn off the ETERNUS DX.
•
To turn off the ETERNUS DX, use the Power switch, a power synchronized unit, ETERNUS Web GUI, or ETER-
NUS CLI. If any other method is used to turn off the ETERNUS DX, the replacement cycle for the battery is
shortened significantly because the battery continues to charge and discharge.
•
After power-off, wait for about one minute before turning power on again.
2. Basic Operation
Powering On and Off
56
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0
To Next Page
Loading...
