This section explains how to use the Power switch to turn off the ETERNUS DX.
For other procedures, refer to the related manuals.
1 Press and hold the Power switch of the controller enclosure for four seconds or more.
Controller enclosure
Power switch
The READY LED on the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the READY
LED turning off and the POWER LED turning off, the ETERNUS DX power may turn on.
2 The power of the
ETERNUS DX is disconnected.
When the power is disconnected, the POWER LED of the controller enclosure and the POWER LEDs of the
drive enclosures are turned off.
2. Basic Operation
Powering On and Off
57
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems
Operation Guide (Basic)
Copyright 2018 FUJITSU LIMITED
P3AM-7742-12ENZ0
To Next Page
Loading...
