Fujitsu ETERNUS LT260 - Saving, Restoring and Resetting the Library Configuration; Figure 2.3 Save;Restore Configuration

Chapter 2 Operating the Library
2.5 Configuring the Library
FUJITSU Storage ETERNUS LT260 Tape Library User’s Guide -Panel Operation-
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0
23
2.5.2 Saving, Restoring and Resetting the Library Configuration
From the Configuration > System > Save/Restore Configuration screen you can save the library configuration
settings to a file, restore the settings, or reset the library configuration. The saved configuration database will
make it easier it recover the library configuration if you need to replace the base module or base module con-
troller.
When the library is configured or set after purchasing the LT260 or when the library configuration or setting
is changed during operation, make sure to save the library configuration settings as a file. The saved library
configuration setting file can be restored in the library using the operator panel or the remote panel. Keep
the latest library configuration setting file in a safe location. This file may be required for maintenance.
Figure 2.3 Save/Restore configuration
■ Saving the library configuration to a file
Procedure
1 Navigate to the Configuration > System > Save/Restore Configuration screen as shown
above.
2 For saving the configuration file to a USB device on the library, insert a USB flash drive into
one of the USB ports on the base module.