Fujitsu ETERNUS LT260 - Configuring SNMP; Figure 2.14 SNMP

Chapter 2 Operating the Library
2.5 Configuring the Library
FUJITSU Storage ETERNUS LT260 Tape Library User’s Guide -Panel Operation-
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0
34
2.5.9 Configuring SNMP
This operation can be executed from only remote panel operation.
Use the Configuration > Network Management screen to enable and configure SNMP (Simple Network
Management Protocol), which allows applications to manage the device. The library supports both SNMP
configuration and SNMP traps.
Figure 2.14 SNMP
• SNMP Enabled
When checked, the library can be managed by computers listed in the SNMP Target IP Addresses field.
• Community Name
A string used to match the SNMP management station and library. It must be set to the same name on
both the management station and the library. The default community name is
public .
• Notification Level
The types of events for which the library should send.
- Inactive
No events are sent.
- Critical
Only critical events are sent.