Fujitsu ETERNUS LT260 - Figure 2.42 Clean Drive; Cleaning a Tape Drive

Chapter 2 Operating the Library
2.7 Operating the Library
FUJITSU Storage ETERNUS LT260 Tape Library User’s Guide -Panel Operation-
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0
65
2.7.4 Cleaning a Tape Drive
From the Operation > Clean Drive screen you can initiate a manual drive cleaning operation.
To use the auto-cleaning function, see "2.5.13
Configuring Library Partitions" (page 42) and "5.5.1 Auto-
Cleaning Function" in "FUJITSU Storage ETERNUS LT260 Tape Library Overview".
Figure 2.42 Clean drive
Procedure
1 Select a cleaning cartridge from the Source Elements list. The library uses the barcode label
to identify cleaning cartridges.
If no cleaning cartridges are available, load one into a mailslot or magazine slot.
2 Select the tape drive to be cleaned from the Destination Elements list.
Tape drives currently containing a cartridge are not listed. To clean a tape drive not listed, move the car-
tridge out of the drive.
3 Click Submit.
End of procedure