Fujitsu ETERNUS LT260 - Configuring Event Notification Parameters; Figure 2.16 SMTP

Chapter 2 Operating the Library
2.5 Configuring the Library
FUJITSU Storage ETERNUS LT260 Tape Library User’s Guide -Panel Operation-
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0
37
2.5.10 Configuring Event Notification Parameters
This operation can be executed from only remote panel operation.
From the Configuration > Network Management > SMTP screen you can enable SMTP (Simple Mail Transfer
Protocol) functionality and configure E-mail notification of library events. The library must have network
access to an SMTP server.
Figure 2.16 SMTP
• SMTP Enabled
Check to enable SMTP. When checked, the remaining configurations are active.
• Notification Level
The types of events for which the library should send E-mail
- Inactive
No events are sent.
- Critical
Only critical events are sent.
- + Warnings
Only critical and warning events are sent.
- + Configuration
Only critical, warning, and configuration events are sent.
- + Information
All events are sent.
• SMTP Server
Hostname or IP address of the SMTP server