Fujitsu ETERNUS LT260 - Figure 2.26 Wellness Test

Chapter 2 Operating the Library
2.6 Maintaining the Library
FUJITSU Storage ETERNUS LT260 Tape Library User’s Guide -Panel Operation-
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0
52
3 Select a destination cell from the Destination Elements list.
4 Select the number of cycles.
5 Click Start Test.
End of procedure
2.6.1.5 Wellness Test
• The wellness test exercises a general health check on the library functionality by running the following
partial tests:
- Basic Hardware Review
- Robotics Initialization Test
- Barcode Scanning Test
- Magazine/Mailslot Unlock Motor Test
- Move Media Test
• Running the test requires at least one drive and one tape carting in the library.
• After the test has been started the Stop Test button is active. Clicking the button will abort the wellness test
but not before the current partial test has been completed.
• The test operates over the whole library and does not take into account partition configuration.
• During the test the library is off line.
• The Info column notifies the user about the status and result of each partial test.
To run the system test, navigate to the Maintenance > Library Tests > Wellness Test screen, and then click
Start Test.
Figure 2.26 Wellness test
To run the system test, navigate to the Maintenance > Library Tests > Wellness Test screen, and then click
Start Test.