Working w ith the noteb ook
Wireless LAN/ Bluetooth (device-dependent)
/ UMTS (device-dependent)
The installation o f a radio component not approved by Fujitsu Technology Solutions
GmbH will invalidate the certifications issued for this device (CE).
Switching the wireless components on and off
► Slide the ON/OFF s witch into the "ON"
position to activate the radio components.
Wireless LANWirelessLA NBluetoothBl uetooth
or
► Slide the ON/OFF switch to the
"OFF" position to deact ivate the
radio components.
If you switch off the radio components, the wireless LAN transmission unit (antenna)
and, if present, the Bluetooth and UMTS module will also be switched off.
You can also deactivate the wireless components individually in the BIOS Setup.
For this to occur, you must either not have assigned a supervisor password or if a
supervisor password has been assigned, you must kn ow this password.
Pay attention to the additional safety notes for devices with wireless
components provided in the "Safety" manual.
Details on using Wireless LAN can be found in the online help system
included in the W ireless LAN software.
You can find more information on how to use Bluetooth on the CD you
received with your Bluetooth software.
You can obtain more information on UM TS from your service provider.
Setting up WLAN access
• Requirement: A WLAN must be available a nd you mu st have the
corresponding access information.
Information on configuring the WLAN access can be found in the
documentation for your operating s ystem.
34 A26391-K214-Z200-1-7619, editio n 1
To Next Page
Loading...
