Removing and installing c omponents
during servicing
Attaching the cover
2
1
► Place the cover in the correct mounting position (1).
If you remo ve more than one component at the same time, kee p the screws for the
individual components separately from each other and make sure that you use the
correct screws. If you insta ll the wrong screws, components may be damaged.
► Tighten t he screw (2).
► In sert the battery (see Chapter "
Install ing a battery", Page 25).
Finishing component removal
After you have removed or changed t h e system components as you required, plea se
prepare your device for operation again as follows:
► In stall the battery again (see "
Installing a b attery", Page 25).
► Turn the notebook the right way up again and place it on a flat surface.
► R econnect the cables that you disconnected before.
50 A26391-K214-Z200-1-7619, editio n 1
To Next Page
Loading...
