Fujitsu LIFEBOOK A1130 - Setting Supervisor and User Password; Changing the Supervisor or User Password; Removing Passwords; Password Protection for Booting of the Operating System

Security functions
Setting supervisor and user password
► Start the BIOS Setup Utility and go to the Security menu.
► Select the Set Supervisor Password field and press the Enter key.

With Enter new Password : you are asked to enter a password.
► Enter the password an d press the Enter key.

Confirm new Password requires you to confirm the password .
► Enter the password again and press the Enter key.

Changes have been saved is a confirmation that the new password has been saved.
► To set the user password, select Set Use r Password and proceed exactly as
when confi guring the supervisor password.

If you do not want to change any other settings, you can exit BIOS Setup Util ity.
► In the Exit menu, select the option Save C hanges & Exit.
► Select Yes and press the Enter key.
PasswordSupervisor passwor
d
Userpassword

The notebo ok will be rebooted and the new password will come into effect. It will now be
necessary to first ente r your supervisor or user password in order to open the BIOS Se tup U tility.
Please note that the user password only provides access to a few of the BIOS settings.
Changing the supervisor or user password
You can only c hange the supervisor password when you have logged into the
BIOS Setup U tility with the supervisor passw ord.
PasswordSupervisorpasswordUserpassword
► Call the BIOS Setup Utility and go to th e Security menu.
► When changing the password, proceed exactly as for password assignment.
Removing passwords
To remove a password (without setting a new password) perform the following steps:
PasswordSupervisor
password
Userpasswo
rd
► Start the BIOS Setup Utility and go to the Security menu.
► Highlight the Set Supervisor Password or Set User Password field and press the Enter key.

You will be requested to enter the current password by the Enter Current Password prompt.
You will be r equested to enter a new password by the Enter New Password prompt.
► Press the Enter key twice.
► In the Exit menu, select the option Save C hanges & Exit.
► Select Yes and press the Enter key.

The notebook will now reboot with the password removed.
Removing the supervisor passw ord simultaneously deactivates the user password.
Password protection for booting of the operating system
With the supervisor password you have set in
the BIOS Setup Utility (see
section "
Setting supervisor and user passw
ord", Page 37), you can also
prevent booting of the operating system.
Ope
rating sys tem
A26391-K214-Z200-1 -7619 , edition 1 37