Fujitsu ScanSnap S1300

Using the ScanSnap in Various Ways (for Windows users)
136
Using the ScanSnap in Various Ways
This section explains how to use the ScanSnap in various ways.
■ Scanning Only One Side of a Document
By default, pressing the [Scan] button performs scanning in Duplex mode.
When you want to scan in Simplex mode, change the settings by following the procedure
below.
1. Select [Scan Button Settings] from the Right-Click Menu.
Refer to "Right-Click Menu" (page 41) for more information about the Right-Click Menu.
D The ScanSnap setup dialog box appears.
2. Select [Simplex Scan (Single-sided)] from the [Scanning side] drop-down
list in the [Scanning] tab.
3. Click the [OK] button to close the ScanSnap setup dialog box.