Fujitsu ScanSnap S1300 - Page 150

Using the ScanSnap in Various Ways (for Windows users)
150
2. Place the documents at the center of the ADF paper chute (cover).
z Place all documents over one another above the pick roller (center).
Documents that are not placed above the pick roller cannot be fed.
z Adjust the side guides to the widest document to be scanned.
z Carefully load small documents that cannot reach the side guide straight into the ADF
paper chute (cover). If the documents are skewed during scanning, the quality of
scanned image data may be degraded (partly lost image data/slant lines produced) or
scanned image data may be output in a different size than the original. If you have
difficulties in scanning the documents straight, it is recommended to scan documents in
several batches, documents of the same width being in the same batch, and enable
continuous scanning.
z Note that documents that cannot be guided by the side guide may cause paper jams.
Width of the pick roller