Chapter 6 Information About Hardware of M8000/M9000 Servers 115
Notes on raidctl(1M) Command
The following options of the raidctl(1M) command can not be used because the
hardware specifications do not support them.
■ raidctl -C -r 1E (To create a RAID 1E)
■ raidctl -c -r 1E (To create a RAID 1E)
■ raidctl -a (To assign hot-spare disks)
■ raidctl -p (To set the cache)
■ raidctl -C -z (To specify the volume capacity)
Notes on DVD Drive and Discs
See the "Notes on DVD Drives and Discs in SPARC Enterprise" on the website below
before using the CD/DVD discs in the standard DVD drive mounted in this server.
http://www.fujitsu.com/sparcenterprise/manual/
Notes on the Use of USB Memory
To execute the dumpconfig(8), restoreconfig(8) or snapshot(8) command, if
you specify USB memory as the destination to store data, prepare the USB memory
as a medium in advance.
The data stored will include the information about the system. To use USB memory,
you need to pay attention to the management of the USB memory in which the data
stored, from the data security viewpoint.
We do not provide guarantees to every USB memory from any manufacturers that
currently on the market against its connectivity to XSCF and proper operation.
Depending on the USB memory in use, defects such as the XSCF firmware error or
reset may occur. In case such defects occurred, stop the use of USB memory
immediately.
To connect the USB memory to the USB port for XSCF, connect the USB memory
directly to the USB port. If connected via USB hub or USB extension cables, it may
cause errors.
To Next Page
Loading...
