EasyManua.ls Logo

Fujitsu SPARC Enterprise M3000

Fujitsu SPARC Enterprise M3000
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3 Information About Software 63
Oracle Solaris OS Issues Fixed in Oracle Solaris 10
8/11
TABLE 3-5 lists issues that have been fixed in Oracle Solaris 10 8/11 OS. You might
encounter them in supported releases earlier than Oracle Solaris 10 8/11.
TABLE 3-5 Oracle Solaris OS Issues Fixed in Oracle Solaris 10 8/11
CR ID M3000
M4000
M4000
M8000
M9000 Description Workaround
6344060 O A lot of following ereports are
outputted when both interfaces bge1
and bge2 are in use.
ereport.io.device.badint_limi
t
ereport.io.service.lost
This issue is caused on the M3000
server with SPARC64 VII+ processors.
This has been fixed in patch 144563-
02.
[Workaround]
No workaround is available.
6794630 O An attempt to use the GUI to install
Oracle Solaris OS in a domain larger
than 2TB might fail.
This has been fixed in patch 124630-
45.
[Workaround]
Use the Command Line interface to
install Oracle Solaris OS.
6966086 O bge interface can not enable Jumbo
Frame function.
This issue is caused on the M3000
server with SPARC64 VII+ processors.
This has been fixed in patch 144563-
02.
[Workaround]
No workaround is available.
7009474 OOOAfter applying 144563-01 or 144563-02
patch, bge interface does not display
link up/down message on console
and syslog when
plugging/unplugging.
This has been fixed in patch 144500-
19.
[Workaround]
Check the link status by using the
"link_state" parameter from the
kstat(1M) output.

Table of Contents

Other manuals for Fujitsu SPARC Enterprise M3000

Related product manuals