Chapter 3 Information About Software 23
XCP Issues Fixed in XCP 1121
TABLE 3-2 lists XCP issues fixed in XCP 1121.
XCP Issues Fixed in Releases Earlier Than XCP
1121
TABLE 3-3 lists XCP issues that have been fixed in releases earlier than XCP 1121.
TABLE 3-2 XCP Issues Fixed in XCP 1121
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
RTIS1-
151212-001
OOOIf the SNMP Agent Status setting was
changed when in the enable state,
SNMP Agent Status becomes disable.
You can check Agent Status from the
Agent Status display of the
showsnmp command.
After changing the SNMP Agent
Status setting once to disable with the
setsnmp command, set Agent Status
to enable with the setsnmp command.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
RTIF1-
070418-004
O O All domains must be powered off
before upgrading the XCP.
Power off domains before using the
flashupdate(8) command to
upgrade XCP firmware.
RTIF1-
070418-005
O O If you log in to the XSCF while it is
still booting, you may get a bash$
prompt instead of the XSCF> prompt,
and be unable to perform most
operations.
Log out of the bash$ prompt and
wait for the XSCF to finish booting.
To Next Page
Loading...
