24 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
RTIF1-
070418-009
OOOWhile XSCF is running, a process may
go down, a watchdog timeout may
occur, or a hang-up may occur. After
this, XSCF may reset.
M8000/M9000 servers:
Check that XSCF is started. If there is
XSCF unit which is not started,
execute the replacefru(8)
command, and then uninstall the
XSCF unit and install it again. Or
stop all the domains and then execute
the system power off/on (AC
OFF/ON). To turn on the system
power that you turned off, wait at
least 30 seconds before power-on.
M4000/M5000 servers:
Check that XSCF is started. If not
started, stop all the domains and then
execute the system power off/on (AC
OFF/ON). To turn on the system
power that you turned off, wait at
least 30 seconds before power-on.
M3000 server:
Check that XSCF is started. If not
started, stop the domain and then
execute the system power off/on (AC
OFF/ON). To turn on the system
power that you turned off, wait at
least 30 seconds before power-on.
RTIF1-
070418-010
OOThe showdomainstatus -a
command shows domain status as
Powered Off, but the showboards -a
command shows the domain is
testing.
Use the showboards command to
check the status of domain power.
The showdomainstatus command
takes a longer time to show the
correct status.
RTIF1-
070418-011
O O Some commands that update
configuration data take a relatively
long time to execute.
Do not cancel set* commands. They
appear to hang, but eventually
complete in about 30 seconds.
RTIF1-
070418-012
OOThe fault (memory.block.ue) is
encountered and reported
periodically.
An uncorrectable error exists in a
DIMM and the DIMM should be
replaced.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
