Fujitsu SPARC Enterprise M3000

Chapter 3 Information About Software 53
RTIF1-
130404-001
OOOIf the domain POR reset is executed
while a domain shutdown is being
executed, the domain status may be
erroneously displayed as Running
(Waiting for OS Shutdown) after
the domain is restarted.
Once the domain shutdown
processing is completed, execute the
domain POR reset.
To restore, restart the domain.
RTIF1-
130404-002
OOOIn an environment in which RCI is
used, the setrci -c state command
may not correctly display the power
status of the server.
If the above status occurs in a
configuration with multiple servers
and I/O units connected by RCI, the
I/O unit power may erroneously be
turned off when the power to one
server is off.
If the power status display is incorrect
for a server, first turn off the power to
the server. If the power to the server
cannot be turned off, disconnect the
RCI cable of the server, together with
the T-branch connector, and then turn
off the power.
After turning off the power to a server
that does not correctly display the
power status, restore the system by
first disconnecting the server and then
restarting the input power (AC
OFF/ON).
RTIF1-
130404-003
OOOIn a configuration with multiple servers
and I/O units connected by RCI,
connecting a powered-on I/O unit to a
powered-off server with an RCI cable
may erroneously turn off the I/O unit
power.
Connecting with the power off in cases
where the server RCI settings are
initialized does not cause a problem.
To connect a powered-on I/O unit to a
server with an RCI cable, either connect
the I/O unit before turning on the server
input power (AC ON), or connect the I/O
unit to the server when the server power
is on.
RTIF1-
130719-001
O O If a memory failure occurs after the
following error is detected, POST
diagnosis may hang up without
isolating the faulty memory.
Msg: DIMM serious error
Msg: Unexpected Trap type
(tt=0x32)
No workaround is available.
RTIF1-
130801-001
OOOThe following error log may be registered
when the restoredefaults(8) command is
executed on XCP 1115:
XSCF self diagnosis warning
detection.
This error log may be ignored.
This trouble can be worked around by
re-setting the XSCF configuration.
As a permanent solution, upgrade to
XCP 1116 or newer.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround